Epoxy Glass -Epoxy Adhesive, Thixotropic Colourless, Transparent Mat Without Added Solvents

Bi-component epoxy adhesive, thixotropic, colourless transparent mat, practically odourless. Formulated for the permanent bonding of granites and marbles, it is suitable for bonding any kind of natural or engineered stone also to heterogeneous materials as it performs a good and very good adhesion on wood, metal, glass, concrete. After hardening, it is characterized by its high vitreous structure. Adheres even on difficult surfaces or humid materials where the polyester adhesive have poor or null adhesion. Its thixotropic characteristic makes is suitable for application on vertical surfaces and the negligible shrinkage allows the reparation of deep micro-cracking and hollows by only one operation.

FIELDS OF USE Bonding of any kind of stone and ceramic materials, both natural and synthetic, between them or to heterogeneous supports such as metal, wood, glass, concrete: CHARACTERISTICS - Very good adhesion between different materials and supports - Adhesion on humid materials - High resistance to the atmospheric agents, acid rains, sea water - High resistance to the solvents, basic environment (so, suitable for concrete) and acids - Almost null shrinkage - Practically odourless

WARNING - avoid use and bonding at temperatures lower than +10°C (50°F). - It doesn’t adhere to silicon - It doesn’t adhere to polyethylene - It doesn’t adhere to teflon - It doesn’t adhere to some plastics - use tools perfectly clean and not contaminated by other substances (rusty knifes/spatula, etc.) - the action of the sunrays and of sources of UV rays may be cause of yellowing or opacification of the products

HOW TO USE

PREPARATION OF THE SURFACES. Clean the surfaces carefully and remove any trace of dust, concrete, gypsum, greasy substances, etc. Better adhesion if the support is slightly roughened.

PREPARATION OF THE TEXTURE. Mix carefully the component A and the component B in the exact ratio as indicated A:B=100:50. It is suggested the mixing of small quantity (max. 400-500 grams) to avoid a too much short time of use before the hardening reaction starts.

APPLICATION. Apply the obtained texture on the clean and dry support by using a toothed putty knife. In case of application to the iron, it is advisable the iron is sandblasted or anyway roughened. After 8 to 10 hours it is possible to move the bonded piece and after 24 hours from the application the piece can be worked, grinded/polished

IMPORTANT - Do not use adhesive already in gelling phase - Do not put again into the can the adhesive not used. - Store at temperature between +10°C and +35°C (50°F and 95°F) - The hardening is faster with the high temperature and slower with the low temperature

MIXING RATIO Component A : Component B = 100 : 50

PACKAGING Set A+B of 1,5 kg.. net (Component A = kg. 1,ooo Component B = kg. 0,5oo)