Epoxy Glass Fluid- Transparent Epoxy Adhesive Glass Effect - Without Added Solvents

Bi-component epoxy adhesive transparent and practically odourless. Formulated for the permanent bonding of granites and marbles, also of very light colours, it is suitable for bonding any kind of natural or engineered stone also to heterogeneous materials as it performs a good and very good adhesion on wood, metal, glass, concrete. After hardening, it is characterized by a very high transparency and vitreous structure. Adheres even on difficult surfaces or humid materials where the polyester adhesive have poor or null adhesion. Its negligible shrinkage allows the reparation of deep micro-cracks and hollows by only one operation.

FIELDS OF USE Bonding of any kind of stone and ceramic materials, both natural and synthetic, between them or to heterogeneous supports such as metal, wood, glass, concrete:

CHARACTERISTICS - Very good adhesion between different materials and supports - Adhesion on humid materials - Very high transparency - Resistant to the atmospheric agents, acid rains, sea water - Resistant to the solvents, basic environment (so, suitable for concrete) and acids - Negligible yellowing - Almost null shrinkage - Practically odourless

WARNING - Avoid the use and the bonding at temperatures lower than +10°C (50°F) - It doesn’t adhere to silicon - It doesn’t adhere to polyethylene - It doesn’t adhere to teflon - It doesn’t adhere to some plastics - the action of the sunrays and of sources of UV rays may be cause of yellowing or opacification of the product

HOW TO USE

PREPARATION OF THE SURFACES. Clean the surfaces carefully and remove any trace of dust, concrete, gypsum, greasy substances, etc. Better adhesion if the support is slightly roughened.

PREPARATION OF THE TEXTURE. Mix carefully the component A and the component B in the exact ratio as indicated A:B=100:50. It is suggested the mixing of small quantity (max. 400-500 grams) to avoid a too much short time of use before the hardening reaction starts.

APPLICATION. Apply the obtained texture on the clean and dry support by using a toothed putty knife. In case of application to the iron, it is advisable the iron is sandblasted or anyway roughened. After 8 to 10 hours it is possible to move the bonded piece and after 24 hours from the application the piece can be eventually grinded/polished

IMPORTANT - Do not use adhesive already in gelling phase - Do not put again into the can the adhesive not used. - Store at temperature between +10°C and +35°C (50°F and 95°F) - The hardening is faster with the high temperatures and slower with the low temperatures

MIXING RATIO Component A : Component B = 100 : 50

THICKNESS The best adhesive characteristics are obtained with thicknesses of adhesive from 0.3 to 1.0 mm

PACKAGING Set A+B of 1,5 kg.. net (Component A = kg. 1,ooo Component B = kg. 0,5oo)

STABILITY The product kept into the original packing, intact and sealed, and stored in dry place at temperature of +15°C and +35°C (50°F - 95°F), has a stability of 12 months. Protect from frost the stored cans/tins