Table Bar Wood Panel Clear Epoxy Resin Stone Glue

[Scope of application]

It is mainly used for bonding and repairing stone materials,edge compound of table and panel,and also has good bonding effect on ceramics,metals and concrete.

[Use steps]

1. The water used for cleaning plate should be clean and pollution-free.

2. The board to be bonded shall be free of impurities such as dust, clay, sand, oil and so on.

3. The board to be bonded must be dried, and can be dried by drying or natural air drying.

4. The bonding surfaces of the plates to be bonded must be smooth or coincide with each other.

5. Mix the glue in proportion A:B=1:1 (weight ratio) and mix well.

6. Special toner must be used in stone.

7. Use a scraper to scrape the glue back and forth, and apply the glue evenly on the board. According to the loose situation of the material, one-sided or two-sided glue can be used.

8. Adhesion of sheet metal, hand-to-hand staggering of sheet metal and pressure, excluding air between sheets, so that the glue is fully filled, must have appropriate glue outflow;

9. Align the plate up and down and press it. The pressure should be evenly distributed. The pressure can be determined according to the actual situation.

10. Static solidification after pressurization. It can be loosened after solidification at room temperature (25 C) for 1-2 hours at the beginning of solidification. It can be put into the next process after 24 hours.

11. Before the adhesive is cured, please use special cleaning agent to clean the tool before it is used. Scrape off the remaining rubber before the glue overflowing from the stone edge is cured