Granite tile slabs, french limestone, italian marble, ceramic, cement, terracotta, glass, quartz , porcelain tiles
Granite tile slabs, french limestone, italian marble, ceramic, cement, terracotta, glass, quartz , porcelain tiles
For use on LIMESTONE, MARBLE, SANDSTONE, GRANITE, QUARTZ, CEMENT TILES, TERRACOTTA & CONCRETE.
Rock Shield sealer is a high performing ecological sealant, which prevents staining from environmental elements, dirt and grime along with accidental spillages such as oil, grease, coffee, red wine, paint and much more. It is an environmentally friendly, non hazardous product that is safe to use around children, pets, plants and aquatic life. Exceptionally easy to apply.
NO VOC (Volatile Organic Compounds)
NO PBT (Persistent, Bioaccumulative & Toxic)
Stock Sizes: 1 Quart, 1 Gallon & 6.6 Gallon Drum
Usage: Commercial & Residential; Interior & Exterior applications.
Application Conditions/Limitations
Substrate & Ambient temperature: 41°F to 104°F
Substrate moisture: 5% maximum
Recommendations
• Keep away from children. Avoid contact with skin. Wear protective gloves & glasses.
• For best results clean and seal once per year.
• Do not use 4 hours before or 4 hours after rain.
• Do not apply during rain or frost and when temperature is below 41°F or above 104°F.
• Do not use on polished closed surfaces.
* Depending on weather, sealer can dry within hours.
* For best results clean and seal once per year.
Limestone & Encaustic Cement Tile | Quart: | 45- 55 | SF | Gallon: | 180-220 | SF | 6.6 Gallon: | 1, 188-1,452 | SF |
Concrete Paving & Terracotta | Quart: | 30- 40 | SF | Gallon: | 120-160 | SF | 6.6 Gallon: | 792 -1,056 | SF |
Granite & Marble | Quart: | 90-130 | SF | Gallon: | 360-520 | SF | 6.6 Gallon: | 2,376-3,432 | SF |
1 QUART
1 GALLON
6.6 GALLON
Untreated Surfaces
Spills penetrate deep into the pores of an untreated surface leaving hard to remove or permanent staining.
Treated Surfaces
Sealing the surface creates a breathable
moisture repellent shield that prevents
spills and environmental weathering
sinking deep into the surface.
ALWAYS TEST ON A SMALL AREA FIRST
Substrate Quality: Cracks must be repaired using a mortar or jointing repair system.
Moisture content should be less than 5% to a depth of 1 cm.
Substrate Preparation: Remove and clean any dust, dirt, oil, efflorescence, organic growth and old paint.
1. Ensure surface is clean, dry & dust free.
2. Shake well before use, apply using a low pressure sprayer, roller or brush.
3. Apply sealer until surface is saturated. Distribute evenly to prevent pooling.
4. Remove excess product after 30 mins. Allow 24 hours to dry.
Apply second coat while wet; within 10 minutes of first coat. Don’t allow product to dry between coats.
Once surface is dry, sealer cannot be re-applied. Water repellency may take 7 days to reach 100% effectiveness.