Sealer’s Choice® Gold, Enrich’N’Seal™ , Ultra-Solv® , Stone Deep Clean , Poultice Stain Remover , Penetrating Sealer
Sealer’s Choice® Gold, Enrich’N’Seal™ , Ultra-Solv® , Stone Deep Clean , Poultice Stain Remover , Penetrating Sealer
Floor Shine & Hardener gives a clear, durable floor finish that resists surface abuse and leaves a beautiful high-sheen finish. May also be used for pre-grouting protection on unglazed porcelain and crackled glazes.
Floor Shine & Hardener Key Features
Sealed Saltillo, terra-cotta and adobe, quarry, slate and sandstone. Internal dry areas use only.
USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product. Surface should be dry, clean and free of any existing coatings. Do not apply directly over silicone sealers, oil or wax based finishes. Aqua Mix® Sealer & Coating Remover will strip the surface and remove wax or old acrylic finishes. Floor Shine & Hardener can be applied over any Aqua Mix® sealer except Stone Enhancer and Enrich’N’Seal. Test product in obscure area to ensure desirable results.
The Stone, Tile or Grout must be dry prior to applying sealer – the following document explains in detail the definition of the term “dry” as it relates to sealer application. READ MORE
Read entire label before using. If an Aqua Mix® sealer is used, allow sealer to cure a minimum of 24 hours unless otherwise indicated on sealer label. Unglazed surfaces must be sealed prior to using Aqua Mix® Floor Shine & Hardener. Surface must be clean, dry and sealed. Apply by pouring a small amount of product directly onto a sealed floor and spreading evenly with a sponge mop or paint pad applicator. Avoid overlapping and puddling. Two to three coats are recommended for a high shine. If 2 or more coats are applied, allow a minimum of 1 hour drying time between coats. Clean applicator tools with soap and water after each use. May be reapplied as needed to surface that is clean and dry.
Apply over clean unglazed porcelain tile or crackled finish tile a minimum of 2 hours prior to grouting. Follow application procedures above. After grout clean-up, any remaining residue of Floor Shine & Hardener can be removed using Aqua Mix® Heavy Duty Tile & Grout Cleaner following product directions. Unglazed surfaces must be sealed prior to using Aqua Mix® Floor Shine & Hardener.
Clean tools with mineral spirits immediately after use