SNIC Gang Saw 80 Blades Block Cutter

This 80-blade gangsaw is characterized by the raising of the block during the sawing phase.
General characteristics:
Flywheel in two halves diameter 3.5m.
Main battery shaft and crank made of high resistance forged steel, rotating in high quality spherical roller bearings.
The main plummer block, made of cast steel, is completely immersed into the concrete, providing a very strong anchorage to the foundations thus enabling an operation free of vibrations which are dangerous to the machine and the diamond blades.
The main motor is powered through a soft starter to control the starting speed and time.
The connecting rod, made of high quality steel, guarantees a high resistance to the dynamic stresses generated.
The main frame is totally fabricated from high strength steel, dimensioned to guarantee an absolute rigidity and stability under load.
The sliding system is made of specially designed sliders, completely immersed in oil.
The motorized block carrying trolley enters the machine from the front side and is automatically locked to the lifting platform as it starts to lift. This lifting motion is driven by steel screws and alloyed nuts with trapezoidal threads, amply dimensioned. The sliders on the columns, prismatic and flat, are made of Teflon. The whole lifting system is protected by polyurethane bellows.
The lifting platform speed variation is achieved by a group of gearboxes and clutches controlled by an inverter.
The nuts and sliders of the lifting platform are equipped with safety devices that stop the machine as soon as the wear becomes excessive.
The machine stops automatically if there is a drop of pressure in the cooling water.
The main chassis is equipped with a set of steps and passage ways, anti-slip and anti-accidents with pipe rails all around, to allow access to the top part of the machine.

Parameters	Unit	SNIC Gang Saw 80 Blades
Max vertical discs /blade no	nr	80
Installed power	hp	150
Block max. length	mm	3200
Auxiliary motor power	hp	7.5
Max. block width	mm	2000
Block max. height	mm	2000
Flywheel diameter	mm	3500
Strokes of the blades	mm	800
Platform upward speed	cm/hour	10 to 45
Cooling water min. pressure 1.5 bar	L/min	10
Cycles per minute	r/min	80
Flywheel speed	rpm	80