Squaring or Profiling Wire for Granite/Marble

Squaringor Profiling Wire for Granite

1. The wire allows significantly greater sawing heights than large discs. It is possible to cut large block by diamond wire;
   2. Thinner cutting width, and more precise;
   3. By virtue of its reliability, adjust the cutting techniques according to different stone material;
   4. Noise nuisance generated by diamond wire saw is significantly less than produced by other sawing techniques;
2. Less pollution

Squaringor Profiling Wire for marble

1.Smooth cutting & more precise;
2. Low power consume and less raw material waste;
3. Low noise and less pollution;
4. Easy manipulation and with low cost.

Other specifications are available upon customer's requirements.

Recommendations:

1. The rotation of the wire should be regularly checked.
2. The worn condition of beads should be regularly inspected.
3. The worn condition of connections & the beads near connections should be regularly checked. Change connections when it needs.
4. The cable tension is set in 250-300kg (Φ4-5mm cable).
5. During the sharpening of a new wire, the liner speed should be reduced 2-3 m/s from the above standard.
6. Water requirement is between 15-25L/min.