MP90 ECO XTREME

EXTREME ECO-COMPATIBLE WATER- AND OIL-REPELLENT PROTECTION

WHAT'S IT FOR

• Water- and oil-repellent with natural effect.

• The best environmentally-friendly stain protection for porcelain tiles, natural stone, marble and granite with polished, brushed and matt honed finishes.

• Reduces absorption without affecting the material\'s natural look.

• It waterproofs, protects and facilitates cleaning.

• It is also ideal for grouting joints, ceramic and crackle effect surfaces, grit, resin-marble, and stone slabs.

• Is also suitable for treating coloured concrete tiles and reconstructed stones.

• It provides an anti-graffiti protection that prevents graffiti paint from bonding to surfaces. It speeds the cleaning process because graffiti can be easily removed.

• Water- and oil-repellent: it hampers the absorption of common watery and oily stains.

ADVANTAGES

• THIS PRODUCT HAS EXTREMELY LOW VOC EMISSIONS: CERTIFIED BY GEV AND MARKED EC1PLUS.

• CONTRIBUTES TOWARDS LEED CREDITS.

• HYDROCARBON SOLVENT FREE: ENVIRONMENTALLY-FRIENDLY TREATMENT.

• DUE TO ITS WATER-BASE, IT WITHSTANDS RESIDUAL HUMIDITY AND CAN THEREFORE BE APPLIED 24-48 HOURS AFTER THE INITIAL WASH, MAKING TREATMENT QUICKER.

• SINGLE-COAT APPLICATION: APPLY AND RUB IN GENTLY UNTIL COMPLETELY ABSORBED.

• DOES NOT FORM SURFACE FILM AND DOES NOT YELLOW.

• IT IS IDEALLY SUITED FOR PROTECTING KITCHEN AND BATHROOM TOPS.

• THE SURFACE CAN BE WALKED ON AFTER JUST 2 HOURS*.

• THE TREATED SURFACES ARE SUITABLE FOR FOOD CONTACT.

• *APPLICATION CONDITIONS:

IDEAL FOR

• Polished Porcelain Tiles

• Marble And Granite

• Natural Stone And Agglomerates

• Concrete

CERTIFICATIONS

• 

  CERTIFIED GEV-EMICODE®
  

  This product has extremely low VOC emissions: certified GEV-EMICODE® - EC1Plus

• 

  LEED CREDITS
  

  This product has extremely low VOC emissions and contributes towards LEED credits.

METHOD OF USE

No dilution required: ready to use.

Application: Shake before use.
For materials with matt finish (natural stone, terracotta, agglomerates, concrete tiles):Apply MP90 ECO XTREME evenly and continuously on a clean and dry surface using a brush or fleece pad, wetting the grout lines as well.Dab any excess product with a clean cloth before it dries. On highly absorbent materials, apply two coats of product with a 20-minute interval in between.For polished porcelain tiles, natural stone, agglomerates with glossy finish:Apply MP90 ECO XTREME on a clean and dry surface, wetting the material and grout lines completely using a brush or fleece pad.Before the product dries (roughly 10-15 minutes), rub it using a microfibre cloth wetted with the product to favour its penetration. Dry the surface with a clean cloth. To speed up the process, it is possible to treat the surface with a single-disc floor scrubber.To complete the cycle with the finish:

Before applying to the entire surface, test the product on a small area to check for colour changes. Do not apply the product externally if rain is forecast. Does not protect against acidic aggression.

COVERAGE

APPROXIMATE COVERAGE (1 litre):

• polished porcelain tiles30-50 m2

• Polished Marble/Granite20-30 m2

• Matte honed stone10-20 m2

FORMATS

1-litre cans in boxes of 6